国产有码在线,午夜日韩福利,日本免费一区二区三区

Detail Information

Original Rexroth Ram Pump

We supply real original Rexroth ram pump, the normal models are: A7VO106, A7VO160, A2FO160, A11LVO190, A4VSO450.

The ram pump also called plunger pump, piston pump, is a high pressure pump for aluminum extrusion press. The ram pump is driven by power-driven, principle: piston in the pump diacharge & absorb the hydraulic oil to hydraulic system, for supply the hydraulic oil to hydraulic system.

Guidelines and instructions of Hydraulic ram pump using

1. The transmission shaft of Hydraulic ram pump and the output shaft of motor should be connected by soft connector, after installation, use the hand to try the coupling rotation, and test the tightness whether is suitable or not.

2. The strength of Hydraulic ram pump base should be meet its’ requirement. Notice: if the strength is not enough, the base may be deformation and will cause the Hydraulic ram pump damage.

3. The concentricity of motor and transition connection of Hydraulic ram pump shaft should not bigger ��0.05.

4. The deviation of location hole of Hydraulic ram pump base and shaft center position of motor should not bigger ��0.1.

5. The input shaft of Hydraulic ram pump and the output shaft of motor should be installed at the same level.

6. Using the soft connector, the motor and the coupling sleeve of Hydraulic ram pump should be matched, it can avoid the coupling moving and hit the shaft or the face of pump shell. Warning: during pump installation, if the face of Hydraulic ram pump is hit or coupling moves, it may damage inner parts of Hydraulic ram pump, or Shell face will be wore, the Hydraulic ram pump body will be hot, shake, the flow pressure will be not available.

7. Every element of hydraulic system should be matched, and keep clean. The oil pipe will be trial run as 1.25 times working pressure and acid cleaning and passivation treatment.

8. When install the Hydraulic ram pump, should take protective measures to avoid the Hydraulic ram pump dropping off the ground or causing security incident.

9. Before start on the Hydraulic ram pump, must check the hydraulic oil capacity, cleanliness and make sure there is no any bubble in the hydraulic oil.

10. To avoid the environment pollution, during replace the used working medium, use the barrel to collect the dirt after clean the pressure container, don’t abandon at will.

11. The Pilot oil pressure (outside control oil) of variable pump should be constant atmospheric pressure, the pressure must be above 50KG.

12. Must fully fill the oil in the interstitial hole of pump shell before the pump start on.

13. Must exhaust at the first before the constant flow pump and variable pump start to run.

14. After all preparatory work are completed, use the hand to control the motor several times to drive the Hydraulic ram pump running normally at non-load, after then start to run the machine.